• AutoCAD Architecture
  • Inventor

Create Autodesk factory design assets

This content series covers the critical step of implementing Autodesk Factory Design solution - Factory Assets creation in Autodesk Inventor.


‌

Module overview

This content series covers the critical step of implementing Autodesk Factory Design solution – Factory Assets creation in Autodesk Inventor.

This content series takes approximately 20 minutes to complete. By the end, you will be able to:

  • Set up and configure your own Factory Design implementation.
  • Understand factory design workflows: Inventor, AutoCAD, and Vault.
  • Start using Asset library.

About the author

The content series was prepared by Stephen Porath, the designated support specialist here at Autodesk.

Before you start

  • Make sure you have AutoCAD and Factory Design Utilities installed.
  • If you have technical difficulties, please reach out to product support. 

Module outline

  • Create a factory asset from Inventor

Related learning

Module20 min.Professional
AutoCAD Architecture

View
Module30 min.Professional
Revit, Inventor
Module10 min.Professional
AutoCAD, Inventor
Module30 min.Foundational
Factory Design Utilities, Inventor, AutoCAD
Module30 min.Professional
Inventor
Module50 min.Professional
Inventor Nastran, Inventor
Module1 hr.Professional
FeatureCAM Products
Module1 hr. 20 min.Professional
FeatureCAM Products
Module15 min.Professional
Inventor
Module2 hr.Professional
Inventor