15 min.

Tolerance Analysis

Module overview

In this module, you will learn to set up tolerance analysis, validate the settings, set up an analysis using the assembly constraints, modify the tolerances, and then compare results.

This module takes approximately 15 minutes to complete. 

Module pre-requisites

This module requires user-level knowledge of Inventor and is focused on best practices and its industry applications. If you don't have experiences with this product, we recommend you to take foundational training using one of the resources below:

About the author

This module was created by Thom Tremblay.

Before you start

  • Please make sure you have the Inventor software loaded.
  • If you have technical difficulties, please reach out to product support

Module downloads

These downloadable resources will be used to complete units in this module:

Module outline

  • Download project files