Creating factory assets in Inventor

Module overview

Learn the process for creating parametric factory assets for use with the Autodesk Factory Design Utilities. This starts with reviewing the parametric model in Inventor, then preparing the asset in the asset publishing environment before testing and publishing it to a central asset library.

This content series takes approximately 20 minutes to complete. By the end, you should gain an understanding of:

• An introduction to creating factory assets in Inventor
• Reviewing a parametric Inventor model
• Understanding the Factory asset publishing environment
• Publishing factory assets

About the author

This content series was created by Rusty Belcher, Manufacturing Applications Expert at IMAGINiT Technologies.

Before you start

• Please make sure you have the Inventor and Factory Design Utilities software loaded.
• If you have technical difficulties, please reach out to product support.