20 min.

Defining project settings

Module overview

Although we can preconfigure a lot of settings in our template, sometimes we might what to look at settings specific to the type of project we are working on. We will look at how to create new Structural Load Settings, how to create structural materials that can be used in analysis, and how we can control the display of our annotations. 

This content takes approximately 20 minutes to complete. By the end, you should be able to: 

  • Understand how to configure load settings.
  • Create a structural material.
  • Control annotation display.

Before you start

  • Please make sure you have the Revit software loaded.
  • If you have technical difficulties, please reach out to product support

Module outline

  • Introduction to Defining Project Settings