10 min.

Incorporate parametric bridge parts from Inventor

Module overview

Moving from one Autodesk software to another for the design should not require starting over from scratch. In this module, you learn how to incorporate custom bridge parts in InfraWorks that were created in Inventor.
This module takes approximately 10 minutes to complete. By the end of the module, you should be able to: 
  • Incorporate customer bridge parts from Inventor 

Module pre-requisites

This module requires user-level knowledge of InfraWorks and is focused on best practices and its industry applications. If you don't have experience with this product, we recommend you to take foundational training using one of the resources below:

About the author

This module was created by Russ Nicloy, Civil Solutions Specialist.

Before you start

  • Please make sure you have the InfraWorks software loaded.
  • If you have technical difficulties, please reach out to product support

Module downloads

These downloadable resources will be used to complete units in this module:

Module outline

  • Download project files