Conduct a massing study in Forma

Module overview

Get a hands-on technical lesson where you will learn how to create a project and populate base layers, draw a model and gain insight into key project metrics, analyze sun hours and daylight potential, and compare results of different designs.

This content takes approximately 25 minutes to complete. The objectives:

• Introduction to the workflow.
• Project creation and layer editing.
• Understand the basics of design tooling.
• Perform analysis and visual comparison.

Before you start

• Make sure you have access to a Forma Hub.
• If you have technical difficulties, please reach out to product support.

About the Authors

This content was created by Catharina Lundby and Robin Franke, Customer Success Managers (Forma) at Autodesk.