Module


15 min.

Updating Revit model with changes


Module overview

Once you have performed structural analysis in Robot, you can modify the Revit model with the information. We will change member sizes in Revit using Direct integration with Robot and then update the Revit model with results from Robot and use the Results Explorer to review the analysis.

This content takes approximately 15 minutes to complete. By the end, you should be able to:

  • Change member sizes in Revit using Direct integration with Robot.
  • Review results of analysis in Robot using the Results Explorer in Revit.

About the author

This content was created by Pawel Pulak, Designated Support Specialist at Autodesk.

Before you start

  • Please make sure you have the Revit and Robot software loaded.
  • If you have technical difficulties, please reach out to product support

Module downloads

These downloadable resources will be used to complete units in this module:

Module outline

  • Introduction to Updating the Revit Model with Information from Robot