Create a ProModel simulation for an existing factory layout in AutoCAD or Inventor

Module overview

This content series will demonstrate how to create a process simulation for an existing factory layout using ProModel Simulation. These workflows help to bridge the gap between factory layouts designed using Factory Design Utilities in AutoCAD and Inventor and ProModel's powerful simulation capabilities. 

This content series takes approximately 10 minutes to complete. By the end, you should be able to:

• Define your process flow.
• Launch process simulation.
• Amend line layout in AutoCAD and ProModel.

About the author

This content series was developed using the following Autodesk University Class, which was created by Aaron Nelson, Keith Vadas, and Andrew Schild.

Module downloads

Module outline

• Define your process flow
• Launch process simulation
• Amend line layout in AutoCAD and ProModel
• Create a ProModel simulation for an existing factory layout in AutoCAD or Inventor - Quiz