20 min.

Sharing Views with a Wider Team in Revit

Module overview

The focus of this module is sharing model information with people who do not have Revit. You will learn to create 3D shared views where the user can investigate the model in the Autodesk Viewer.

This module takes approximately 20 minutes to complete. By the end of the module, you should be able to:

  • Share a 3D view from Revit with the wider team. 
  • Navigate around a 3D shared view in Autodesk Viewer. 
  • Create 3D sections and exploded views in the Autodesk Viewer. 

Module pre-requisites

This module requires user-level knowledge of Revit and is focused on best practices and its industry applications. If you don't have experiences with this product, we recommend you to take foundational training using one of the resources below:

About the author

This module was created by Martha Orcutt.

Before you start

  • Please make sure you have the Revit software loaded.
  • If you have technical difficulties, please reach out to product support

Module downloads

These downloadable resources will be used to complete units in this module:

Module outline

  • Introduction - Sharing Views With A Wider Team