Point Cloud Display and Navigation

Module overview

This module will teach you how to navigate and set display options for point clouds.

This module takes approximately 20 minutes to complete. By the end of the module, you should be able to:

• Configure point cloud display settings
• Navigate a point cloud using pan, zoom, orbit, and fly modes
• Use RealView to explore 360° images of scan locations
• Use the Minimap to:
• Switch between scan locations
• Set a User Coordinate System
• Add and modify Elevation Slices
• Add markups, measurements, annotations, and notes to 3D and RealViews

About the author

This module was created by Jason Drew, Technical Account Specialist at Autodesk.

Before you start

• Please make sure you have the ReCap Professional software loaded.
• If you have technical difficulties, please reach out to product support.