30 min.

Return to work: Factory Layout and COVID-19

Module overview

In this module, you will learn a process and the necessary assets to revise and visualize your factory floor making it a safe and productive environment for your returning workers.

Note: the scenarios depicted in this section are generic examples only and should not be considered official guidance in any way. The decisions and planning necessary to open your facility should be accomplished in way of your official city, state, and country guidelines.

This module takes approximately 30 minutes to complete.

Module pre-requisites

This module requires user-level knowledge of Autodesk Inventor and AutoCAD and is focused on best practices and its industry applications. If you don't have experiences with this product, we recommend you to take foundational training using one of the resources below:

About the author

This module was created by Rusty Belcher.

Before you start

  • Please make sure you have Autodesk Inventor and AutoCAD loaded.
  • If you have technical difficulties, please reach out to product support

Module outline

  • Introduction