u4NXa_8iF0hpv4nH4xMDoxOjBzMTt2bJ
Hands-on Lab    TR323048-L
Fusion 360 Introduction to Generative Design
u4NXa_8iF0hpv4nH4xMDoxOjBzMTt2bJ
Collapse Expand

Description

Last year I did an “Introduction to Fusion 360 Generative Design” lecture so this year I think it is time to give the users a chance to see how it works. This time I want to do a hands-on lab where I will break it down in to three areas The Setup, The Analysis and The Results. I hope this will allow the users that are not sure what Generative Design does a chance to walk through the process and see how it works. This will give users who don’t currently use Generative Design but are interested a chance to try out a part and see not just what it does but how it is used.

Key Learnings

  • Define what Generative Design is.
  • Go through a setup for a part.
  • Run through an Analysis.
  • Review the results.

Intervenants

close
Transcript
Fusion 360 Introduction to Generative Design

Partager un cours

Comments